长沙广杰环保热处理油烟净化器 量大从优 厂家直销

广杰—油烟异味一体机系列
GOJEK—soot smell all—in—one series
**较**的净化器品牌之一
One of the world's best—selling brand purifier
98%以上油烟处理效率
90%以上异味处理效率
通过CE、ISO、ESP等质量*认证
**实现低空排放

设备特点
1、产品为自产自销，品质有**
2、核心零件自行开发
3、针对不同产业特性设计适合之机型
4、投保千万产品责任险
5、全机型模块化组合设计
6、设备零件均通过CE、ISO等认证
7、大型餐厅可定制不锈钢产品
8、98%以上除油烟效率，90%以上异味净化效率，目测无烟
9、**的较板电场，能使设备具有较高的除烟效果 
10、美国原装进口UV灯管，使用寿命长达900H
11、具有电源过载保护和变压器过温保护等多重保护功能

设备原理
本产品采用高低压静电净化和UV光解双重作用。含烟异味废气被见机吸入管道后，首先进入初级装置——净化整流室，采用重力惯性净化技术，室内的特殊结构逐步对大粒径污染物体进行分组物理分离，并且均衡整流。分离出的大颗粒油滴在自身重力的作用下流入油槽排出。剩余的小粒径污物进入次级装置——高压静电场，静电场内部分两级，**级为电离区，强电场使微粒带电，成为带电微粒，*二级为集尘区，这些带电微粒到达集尘区后立刻被收集电极吸附，且部分炭化。同时，高压静电场有效地降解有害成分，起到消毒、除味作用。较后通过滤网格栅到达UV光解段，油烟异味进一步被C波紫外线光解，光解后油烟分子链被切断，在排烟管道内被臭氧氧化，被光解氧化的油脂生成二氧化碳、水汽和微量白色粉末，双重高效洁净的空气排出室外。

设备组成部分
预过滤器	去除大颗粒
电离子箱	高效吸收和过滤装置
UVC紫外线系统	去除烹饪及工业气味
活性炭除味系统（可选）	去除烹饪及工业气味
BMS控制系统（可选）	远程监控

安装注意事项Installation notes
14.净化系统内通风量应在净化器额定处理风量内；1the amount of ventilation in the purification system should be within the rated air flow rate of the purifier;
15.净化器安装应保证水平，否则，净化器收集的油会被风机吸出，或放油时不能将净化器内的油放尽； installation should ensure that the level, otherwise, the oil purifier collected by wind suction, or put the oil can not be put in the oil purifier;
16.管道内风速应设计在8-10m/s; wind speed pipe should be designed in 8-10m/s
17.弯头中线半径≥1.5D（若不满足此条件，则变径管风阻会成倍增大） elbow radius is larger than 1.5D midline (if not meet this condition, it will increase the drag reducing pipe)
18.变径管（小变大）斜边与轴线夹角≤70（若不满足此条件，应考虑合理安装导流板。否则，净化器净化效率将大幅度降低而不能达到国家排放标准） tube (small and large) bevel angles with the axis is less than or equal to 70 (if you do not meet this condition, should consider the reasonable installation guide plate. Otherwise, the purification efficiency of the purifier will be greatly reduced and can not meet the national emission standards.





19.变径管（大变小）你斜边与轴线夹角≤150（若不满足此条件，应考虑合理安装导流板。否则，净化器不能发挥器效能）。如图所示；7 tube (big or small) your bevel angles with the axis is less than or equal to 150 (if you do not meet this condition, should consider the reasonable installation guide plate. Otherwise, the purifier can not play the effectiveness of the device. As shown in figure;


20.净化器进风口之前应有一段≥2.5D的直管（若不满足此条件，应考虑合理安装气流均布板和导流板。否则，净化器不能发挥器效能 ）；Before the 8 air purifier should be a straight over 2.5D (if this condition is not met, should consider the reasonable layout and installation flow guide plate. Otherwise, the purifier can not play the effectiveness of the device;
21.风机应安装减振器；fan should be installed vibration damper;

22.风机进出风口应安装软连接； wind turbine inlet and outlet should be installed soft connection;

23.净化器必须可靠接地（净化器有3根出线，红线和绿线接220V/AC，黄绿线接地）purifier must be reliable grounding (purifier has 3 stages, red and green 220V/AC, green line)

24.风向问题：设备出厂均设定为左进风（面对净化器电气箱的门），风向流动邮左进风，反之则为右进风）。若现场需用右进风，电场旋转180°，将弹簧接头由下方移至上方，再将高压线对换则完成了由左进风调整为右进风之过程。wind problem: equipment factory was set up at the left Jinfeng (face purifier electric box door), wind flow post left Jinfeng, whereas right into the wind). If the site use right into the wind, the electric field will rotate 180 degrees, from below to above the spring joint, then on the high voltage line is completed by adjusting inlet for Jinfeng left right.

25.为保证设备的净化效率，设备工作在负风压状态，即风机必须设在设备后面。 in order to ensure the efficiency of the equipment, the equipment works in a negative pressure state, that is, the wind turbine must be located in the back of the equipment.

26.室外安装时，应加装防雨、遮阳的遮阳蓬，以免影响设备的正常使用寿命以及增加不必要的维护费用。 outdoor installation, should be equipped with sunshade rainproof and sunshade, so as not to affect the normal service life of equipment and increase unnecessary maintenance costs.